Stack Pressure Considerations for Room‐Temperature All‐Solid‐State Lithium Metal Batteries

Abstract All‐solid‐state batteries are expected to enable batteries with high energy density with the use of lithium metal anodes. Although solid electrolytes are believed to be mechanically strong enough to prevent lithium dendrites from propagating, various reports today still show cell failure due to lithium dendrit growth at room temperature. While cell parameters such as current density, electrolyte porosity, and interfacial properties have been investigated, mechanical properties of lithium metal and the role of applied stack pressure on the shorting behavior are still poorly understood. Here, failure mechanisms of lithium metal are investigated in all‐solid‐state batteries as a function of stack pressure, and in situ characterization of the interfacial and morphological properties of the buried lithium is conducted in solid electrolytes. It is found that a low stack pressure of 5 MPa allows reliable plating and stripping in a lithium symmetric cell for more than 1000 h, and a Li | Li 6 PS 5 Cl | LiNi 0.80 Co 0.15 Al 0.05 O 2 full cell, plating more than 4 µm of lithium per charge, is able to cycle over 200 cycles at room temperature. These results suggest the possibility of enabling the lithium metal anode in all‐solid‐state batteries at reasonable stack pressures.

Authors

Jean‐Marie Doux; Han Nguyen; Darren H. S. Tan; Abhik Banerjee; Xuefeng Wang; Erik A. Wu; Chiho Jo; Hedi Yang; Ying Shirley Meng

Published

Nov 25, 2019

Journal or venue

Advanced Energy Materials

DOI

10.1002/aenm.201903253

Paper type

journal article

Source

Openalex